Differences

This shows you the differences between two versions of the page.

--- parks [2025/09/22 15:53] – [Ubiquiti OLT to parks] protocol
+++ parks [2026/02/04 13:01] (current) – protocol
@@ Line 1: / Line 1: @@
+===== Fucking debug for rogue =====
+<code>
+PARA OLTs 300xx/400xx:
+conf t
+logging terminal prio 7
+interface gponx/x
+rogue-detection start periodical configure 1 previously-used
+Para desativar a detecção deve-se estar dentro da porta GPON:
+no rogue-detection periodical
+PARA OLTS 1000x/200xx:
+conf t
+logging terminal prio 7
+interface gponx/x
+rogue-detection periodical configure 1 0 127 256 1023 previously-used
+rogue-detection periodical start
+Para desativar a detecção deve-se estar dentro da porta GPON:
+rogue-detection periodical stop
+</code>
 ===== Upgrade Parks from RouterOS =====
@@ Line 47: / Line 73: @@
 ===== Ubiquiti OLT to parks =====
 <code>
-sed  -e "s/,/\n/g" p.json |grep "pppoeUser\|serial"|cut -d "\"" -f 4 |tr '[:upper:]' '[:lower:]'>u2p
+sed  -e "s/,/\n/g" p.json |grep "pppoeUser\|serial"|cut -d "\"" -f 4 > u2p
-while IFS=' ' read -r pppoe serial; do echo -ne "onu add serial-number $serial\n\n"'!'"\n\ninterface gpon 1/5\n onu $serial  ethernet-profile auto-on uni-port 1\n onu $serial vlan-translation-profile access_v10 uni-port 1\n onu $serial upstream-fec disabled\n onu $serial flow-profile bridge\n onu $serial alias $pppoe\n"; done < u2p
+while IFS=' ' read -r pppoe serial; do echo -ne "onu add serial-number $serial\n"'!'"\ninterface gpon1/5\nonu $serial  ethernet-profile auto-on uni-port 1\nonu $serial vlan-translation-profile access_v10 uni-port 1\nonu $serial upstream-fec disabled\nonu $serial flow-profile bridge\nonu $serial alias $pppoe\n"; done < u2p | tr '[:upper:]' '[:lower:]
 </code>
+Modulo SNMPv2 Parks (Template Parks Fiberlink 30028 - 1.1), Template Module ICMP Ping, Template Parks NV3 - Status ONU
+ref: https://suporte.parks.com.br/support/solutions/articles/8000053169--atualizado-rogue-detection